Harman-kardon HK 3485 Bedienungsanleitung PDF herunterladen (Seite 23)

OPERATION

Figure 35 – Controls Behind Door

Radio stations may be selected in one of five ways (see Figure 36):

1. If you know the frequency number, enter it directly by first pressing

the Direct Button on the remote, and then using the Numeric Keys.

2. After you have programmed preset stations (see below), either enter

the preset number (1 through 30) using the remote or use the front-

panel Preset Stations Button to scroll through the list of presets.

3. In Auto Tuning mode, press and hold the Tuning Buttons (front-panel

or remote) to scan in the chosen direction until a station with accept-

able signal strength is detected.

4. In Manual Tuning mode, with each press of the Tuning Buttons the

HK 3485 will tune the next frequency increment (0.1MHz for FM,

or 10kHz for AM) in the selected direction.

5. Press the Preset Scan (P. Scan) Button on the front panel or remote

to scan through the previously programmed preset stations. The tuner

will pause for five seconds at each frequency before tuning to the

next preset. Press the Preset Scan Button again to select the current

station and stop scanning.

When an FM station has been tuned, pressing the FM Mode Button will

switch between stereo and mono tuning, which may improve reception

of weaker stations. See Figure 36.

Figure 36 – Tuning a Station

To store a station in one of the 30 presets (see Figure 35):

1. Tune the desired station.

2. Press the Memory Button on the remote.

3. Use the Numeric Keys to enter the desired preset number.

To clear a station from the preset memory:

1. Tune the preset station using any of the methods described above.

2. Press the Memory Button.

3. Within five seconds, press the Clear Button.

Auto Preset

You may automatically program all FM radio stations in your area that

are received with acceptable signal strength into the HK 3485’s presets.

Press and hold the Auto Preset Button until the Memory and Preset

Indicators flash in the front-panel display. The tuner will automatically

scan through the entire FM band, entering all stations with acceptable

signal strength into the presets until either all 30 presets have been

filled, or the tuner has scanned the band three times.

NOTE: If there are a large number of FM stations in your area,

Auto Preset will overwrite any presets you programmed previously.

Stations with exceptionally strong signals may be programmed

into more than one preset.

Recording

Two-channel analog audio signals, as well as composite video signals,

are normally available at the appropriate recording outputs. Thus, to

make a recording, you need only make sure to connect your audio

or video recorder to the appropriate output jacks, as described in the

Installation section, insert blank media and make sure the recorder is

turned on and recording while the source is playing.

You may monitor your recording if your recorder has separate record

and playback heads. Press the front-panel T-Mon Button to monitor the

recording using the playback head, indicated by the dot to the left of the

Tape Monitor Indicator flashing. This will not affect the recording being

made from the original source. To hear the original source again, press

the T-Mon Button so that the dot to the left of the Tape Monitor Indicator

stops flashing.

If your recorder does not have off-head playback, then you will not hear

anything when you press the T-Mon Button.

NOTE: Please make certain that you are aware of any copyright

restrictions on any material you record. Unauthorized duplication

of copyrighted materials is prohibited by federal law.

HK 3485 OM 2/15/07 4:21 PM Page 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Harman-kardon HK 3485 Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Harman-kardon HK 3485